"Electric Heating Air Dryer": Chassis Material: Corrosion-resistant aluminum-zinc sheet

GD-20 type: length 750mm, width 700mm, height 600mm, voltage 380V, heater adopts stainless steel electric heating pipe sleeve stainless steel heat dissipation fins, large heat generation. Equipped with low noise, axial fan, air volume of about 4800 cubic meters, each equipped with a fully automatic temperature controller, the temperature can be set according to their own needs, set the required low temperature and high temperature, the temperature reaches automatic shutdown, low temperature automatic start, in addition to the controller is equipped with continuous phase loss protection, the electric heating pipe and fan play a protective role, so as to avoid the lack of phase caused by the motor and electric heating pipe damage. In addition, it is equipped with fan delay function, when the machine is started, after the normal heating temperature of the electric heating pipe rises, the fan will open the air supply, and after the electric heating pipe reaches the required temperature in the room, the fan will continue to delay the blowing for one minute and then stop, so as to avoid the temperature of the electric heating pipe being too high and causing damage to other electronic components. The thermostat is also equipped with an automatic induction probe to probe the furnace temperature, after the furnace temperature is too high, the electric heating pipe will automatically power off and stop heating, so that the voltage phase loss can prevent the electric heating pipe from continuing to heat up after the motor burns out, causing the burning of the equipment with too high temperature or some problems. In the case of room temperature, the heating area is about 200-300 square meters, the temperature of brooding breeding is about 38 degrees, and the heating area is about 150-200 square meters.